Used for the maintenance and repair of galvanized areas of sheet angle iron and other structures that have been welded or cut with a torch. This is also used to coat areas against rusting and corrosion that have not been previously protected. Commonly used to protect structures that are too large to disassemble and dip in galvanizing tanks.

PROCEDURE:
Remove all rust, slag and other foreign material from the area to be galvanized. No flux is needed for this process. The base metal must be heated to approximately 600°F (315°C). Rub the rod on the area to be coated, letting the heat from the base metal melt the rod. Do not apply torch directly onto the Gal-viz. Thinning action can be improved by brushing through the molten deposit using a clean wire brush. The alloy can be smoothed out with a paddle or cloth; DO NOT OVERHEAT! This product is intended to be used in the flat position, vertical is not recommended and overhead should never be performed.