Finkl Mold Die Datasheet

Wrought Tool Steel

Supplied by A. Finkl & Sons Co.

Create your free Prospector account to view this complete product datasheet. A free account includes access to hundreds of thousands of detailed technical datasheets. Create Your Free Account
Product Description
Supplied in the pre-hardened condition, approximately 300 Brinell, for injection Plastic molds and zinc die casting dies. Higher hardness, approximately 330 Brinel, is immediately available in certain stcoked sizes and always available on a custom-order basis. Mold Die can also be supplied in the annealed condition.

Mold Die is produced exclusively by the Finkl patented VAD process and provides the cleanest, most homogeneous structure available, giving maximum machinability and polishability in the industry.

Full service metallurgical expertise is available upon request. Mold Die is ALWAYS forged steel from upset ingots with a minimum 5-to-1 reduction of area.

Mold Die is 100% ultrasonically tested to the most rigid industry standards and is fully warranted and approved by all major users.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  • Latin America
  • North America
 
Available Documents
Technical Datasheet (English)
Metals General
Nominal Value
Unit
 
Metal Type
 
 
Metals Type Analysis
Nominal Value
Unit
 
Type Analysis
     
Carbon
%
 
Chromium
%
 
Manganese
%
 
Molybdenum
%
 
Nickel
%
 
Silicon
%
 
Metals Physical
Nominal Value
Unit
 
Density (68°F)
lb/in³
 
Metals Mechanical
Nominal Value
Unit
 
Hardness (HB-Scale)
 
 
Tensile Modulus
ksi
 
Metals Thermal
Nominal Value
Unit
 
Mean Specific Heat
Btu/lb/°F
 
Mean CTE (68°F)
in/in/°F
 
Thermal Conductivity
Btu·in/hr/ft²/°F
 
Notes
1Typical properties: these are not to be construed as specifications.
 
UL and the UL logo are trademarks of UL LLC © 2020. All Rights Reserved.
The information presented here was acquired by UL from the producer of the product or material or original information provider. However, UL assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third party sites is not within our control, and we cannot and will not take responsibility for the information or content.